How do I change the ignition control module on my Audi 80?

I need to replace the ignition control module on my Audi 80 but I am not sure how to do it. What steps should I follow and what tools do I need for this task?

First, disconnect the negative battery cable to avoid any electrical shocks. Then, locate the ignition control module, which is usually attached to the distributor. Use a wrench to loosen and remove the bolts holding the module in place. Once the old module is removed, replace it with the new one and secure it with the bolts. Lastly, reconnect the battery and start your car to test if the new module is working properly.

You will need a few tools, such as a socket set, pliers, and a screwdriver. Before removing the old ignition control module, take note of the wire connections and make sure to reconnect them in the same order when installing the new one. Also, double check that the wires are not damaged or corroded, as this could also cause issues with your car's ignition.